Riprap Sizing Calculator
Maynord (USACE EM 1110-2-1601) and Isbash (1936) riprap sizing for embankment slope protection, channel bank armor, and outfall protection. Returns recommended D30, D50, gradation envelope, and required layer thickness. Includes side-slope and bend correction factors per the EM.
EM 1601 fixed factors: Sf = 1.1 (safety), Cs = 0.30 (riprap shape, blanket thickness), Ct = 1.0 (thickness factor for T = 1·D100). For a flat channel bottom, set side slope n = 0.
Side-slope correction factor K1
| Side slope (V:H) | θ (°) | K1 |
|---|---|---|
| 1:1.5 | 33.7 | 0.51 |
| 1:2 (typical embankment) | 26.6 | 0.72 |
| 1:2.5 | 21.8 | 0.82 |
| 1:3 | 18.4 | 0.87 |
| Horizontal (channel bottom) | 0 | 1.00 |
Worked example
Example — channel bank at a bend
Recommended riprap gradation
| Percent finer by weight | d/D50 (typical) |
|---|---|
| D100 (max) | 1.5 |
| D85 | 1.30 |
| D50 | 1.00 |
| D30 | 0.85 |
| D15 | 0.70 |
References: USACE EM 1110-2-1601 (1991), Hydraulic Design of Flood Control Channels, Chapter 3. Maynord, S.T. (1988). Stable Riprap Size for Open Channel Flows. USACE WES Tech. Rept. HL-88-4. Isbash, S.V. (1936). Construction of Dams by Depositing Rock in Running Water. Trans. 2nd Cong. Large Dams, Washington DC.
Common mistakes
- Using the average channel velocity on the outside of a bend. The bend factor Cv handles part of this, but local velocity at a bridge pier, a constriction or a culvert outlet needs its own method (HEC-23 for piers, HEC-14 for outlets).
- Entering the side slope as H:V. The tool asks for n in 1V:nH. A 2:1 slope is n = 2. Entering 0.5 gives a slope steeper than the stone can stand on.
- Assuming a 40° angle of repose for rounded stone. Rounded river rock has a lower angle of repose than angular quarry stone, which lowers K1 on slopes and raises the required size.
- Specifying D50 without the gradation and thickness. The Maynord method assumes a well-graded blanket at least one D100 thick. A thinner or gap-graded layer does not deliver the stability the equation predicts.
When this calculator doesn’t apply
The method applies to riprap in open channels with gradually varied flow. It does not cover wave attack on shorelines or reservoir slopes, overtopping flow on embankment faces, stilling-basin end protection or local scour at structures. Each of those has its own design method. Dam spillway channels and outlet works are normally governed by USACE, USBR or state dam safety criteria.
Related tools
- Bridge scour (HEC-18) — scour depth at piers and abutments before designing the armor
- Riprap sizing methods reference — Isbash/HEC-11 D50, gradation, filter
- Filter criteria — design granular filter beneath riprap
- Photo-sieve grain size — confirm delivered D50 matches design
- Manning's equation — get the channel velocity to size against
- Wave runup & freeboard — for embankment upstream-slope wave protection